+ Reply to Thread
Results 1 to 4 of 4
  1. Senior Member
    Join Date
    Nov 2009
    Location
    UK
    Posts
    309

    Certifications
    MCSA (2003), MCDST, A+, CCNA, CCNA Security, CCNP R&S
    #1

    Default Files from tftp server

    Reading through the cisco ccna voice book, not long started it. With regards to the IP phone boot process, when the phone downloads the initial configuration file from the tftp server (cnf.xml), are these the files we download from the Cisco site and then transfer to the tftp server? Just that the book states the filenames for each phone are SEPmacaddress of phone, so I'm wondering how the tftp server already has the Mac address of the phone and a specific config file for each when in reality this could be the first time the IP phone has contacted the tftp server? Someone else explain where I might be going wrong with this?
    Thanks
    Reply With Quote Quote  

  2. SS -->
  3. Senior Member pitviper's Avatar
    Join Date
    May 2008
    Location
    Right Coast, US
    Posts
    1,363

    Certifications
    CCNP:Collaboration, CCNP:R+S, CCNA:R+S, CCNA:V(IIUC), CCNA:S, CCENT, CNSS 4011
    #2
    You enter the IP phone MAC address in CUCM (or CUCME) during the initial setup - call manager creates unique config files for each phone, and parkes them on it's TFTP server.
    Reply With Quote Quote  

  4. Senior Member
    Join Date
    Nov 2009
    Location
    UK
    Posts
    309

    Certifications
    MCSA (2003), MCDST, A+, CCNA, CCNA Security, CCNP R&S
    #3
    In most cases then, does this mean the TFTP Server will also be the CUCME or CUCM?

    If not and the TFTP server was totally separate do we need to setup the phone in CUCM (e) and then copy the files to the TFTP server? Just that the book seems to state the TFTP server could be different from the actual CUCM(E) server so I'm puzzled as to how the phone gets the files if this is true.
    Reply With Quote Quote  

  5. Senior Member pitviper's Avatar
    Join Date
    May 2008
    Location
    Right Coast, US
    Posts
    1,363

    Certifications
    CCNP:Collaboration, CCNP:R+S, CCNA:R+S, CCNA:V(IIUC), CCNA:S, CCENT, CNSS 4011
    #4
    Yeah, theoretically you could move the config files to a different physical, non-Cisco server but It’s not commonly done in the real world (and not part of Cisco’s “Best Practices”). You could however do a separate CUCM installation and run the TFTP server service – to keep the load off of your PUB/SUB servers.

    You can specify the location of the config files in CME (under telephony-services) and it will allow you to specify an external location.
    Last edited by pitviper; 01-02-2013 at 07:02 PM.
    Reply With Quote Quote  

+ Reply to Thread

Social Networking & Bookmarks