+ Reply to Thread
Results 1 to 3 of 3
  1. Senior Member
    Join Date
    Dec 2012
    Location
    Chicago, IL
    Posts
    328

    Certifications
    Juniper/Cisco/CompTIA Gandam
    #1

    Default Integrating a CME router into an existing network

    I have a new CME router that I'm integrating into an existing network.

    Trying to come up with things to do to make a smooth transition. Please review the commands to see they are correct.

    (1) Disable DHCP and relay DHCP service to existing network. {no service dhcp && ip helper-address 10.10.10.1}
    (2) Static route from other ports to that port to existing switch. { ip route fa0/1 0.0.0.0 255.255.255.255}
    (3) Enable SSH by giving ip address to int fa 0/1 {int fa 0/1 && ip address 10.10.10.10 255.255.255.0}
    (4) Default gateway to the existing DHCP router { ip default-router 10.10.10.1}


    Anything else? I'll think about setting up FXO/FXS after this but I want to be able to see CME on CCP upon entering those commands.

    Thanks.
    Reply With Quote Quote  

  2. SS -->
  3. Network Engineer Dieg0M's Avatar
    Join Date
    Jun 2013
    Location
    Montreal
    Posts
    853

    Certifications
    CCIE #48240, CCDP
    #2
    Quote Originally Posted by sendalot View Post

    (2) Static route from other ports to that port to existing switch. { ip route fa0/1 0.0.0.0 255.255.255.255}
    What are you trying to accomplish with this command?
    Reply With Quote Quote  

  4. Senior Member
    Join Date
    Dec 2012
    Location
    Chicago, IL
    Posts
    328

    Certifications
    Juniper/Cisco/CompTIA Gandam
    #3
    Quote Originally Posted by Dieg0M View Post
    What are you trying to accomplish with this command?
    I ended up not using it as other ports in the CME router won't be used. I only gave interface an ip address so that I ca access CME.
    Reply With Quote Quote  

+ Reply to Thread

Social Networking & Bookmarks