+ Reply to Thread
Results 1 to 2 of 2
  1. Senior Member
    Join Date
    Dec 2012
    Location
    Chicago, IL
    Posts
    328

    Certifications
    Juniper/Cisco/CompTIA Gandam
    #1

    Default Setting up tftp server on cme router

    Below is the end of "show flash" output (look at the bottom few). I uploaded some firmware for 7940 IP phones.


    Now how do I conjure up the tftp-server command to make IP phones pick these up?
    I looked at some Cisco articles about this but I wasn't sure about the syntax.


    Thanks.


    239 2464 Apr 10 2013 20:42:30 +00:00 home.shtml
    240 130552 Apr 13 2014 20:06:12 +00:00 P0030801SR02.bin
    241 708460 Apr 13 2014 20:07:06 +00:00 P0030801SR02.sb2
    242 130956 Apr 13 2014 20:07:34 +00:00 P0030801SR02.sbn
    243 458 Apr 13 2014 20:07:44 +00:00 P0030801SR02.loads
    Reply With Quote Quote  

  2. Senior Member cisco_nerd's Avatar
    Join Date
    Dec 2010
    Location
    Brisbane, Australia
    Posts
    198
    #2
    Quote Originally Posted by sendalot View Post
    Below is the end of "show flash" output (look at the bottom few). I uploaded some firmware for 7940 IP phones.


    Now how do I conjure up the tftp-server command to make IP phones pick these up?
    I looked at some Cisco articles about this but I wasn't sure about the syntax.


    Thanks.


    239 2464 Apr 10 2013 20:42:30 +00:00 home.shtml
    240 130552 Apr 13 2014 20:06:12 +00:00 P0030801SR02.bin
    241 708460 Apr 13 2014 20:07:06 +00:00 P0030801SR02.sb2
    242 130956 Apr 13 2014 20:07:34 +00:00 P0030801SR02.sbn
    243 458 Apr 13 2014 20:07:44 +00:00 P0030801SR02.loads

    conf t
    tftp-server flash:/P0030801SR02.loads alias P0030801SR02.loads

    You can infer the rest. Change the file path based on where the file exists within flash.
    Reply With Quote Quote  

+ Reply to Thread

Social Networking & Bookmarks