+ Reply to Thread
Results 1 to 3 of 3
  1. Diggin' 4 Cisco Gold ptlinva's Avatar
    Join Date
    Jan 2009
    Location
    Virginia, USA
    Posts
    124

    Certifications
    CCNA, CCENT, MCP, CNE, Red Hat Linux Admin - Diggin' for CCNA Voice!
    #1

    Question Setting up a new wireless controller...

    Hi Everyone,

    I setup my 1st wireless controller from scratch. I followed the video at...

    https://www.youtube.com/watch?v=0ckpts0rvnA

    I did have an issue where I could get my APs to find the WLC but was able to console into them and set the IP addresses and it came up fine.

    I'm able to connect to the SSID and everything seems great... EXCEPT...

    I'm having a routing issue on my router. I can ping the outside world from the router. However, if I ping with a "source", the pings fails. For example, if I type...

    ping 4.2.2.2 source 172.16.1.1

    it fails when I add the source parameter on the ping command.

    Any suggestions on troubleshooting a routing issue? All routes are "connected" routes except for the one static gateway of last resort.

    Thanks in advance for your time and consideration.

    Your friend,
    Paul
    Reply With Quote Quote  

  2. SS -->
  3. Network Engineer Hondabuff's Avatar
    Join Date
    Aug 2012
    Location
    USA
    Posts
    637

    Certifications
    CCNA:S, CCNA, CCENT, CCNP:R&S,MECP, A+, Network+, Security+, Network Security Diploma
    #2
    Quote Originally Posted by ptlinva View Post
    Hi Everyone,

    I setup my 1st wireless controller from scratch. I followed the video at...

    https://www.youtube.com/watch?v=0ckpts0rvnA

    I did have an issue where I could get my APs to find the WLC but was able to console into them and set the IP addresses and it came up fine.

    I'm able to connect to the SSID and everything seems great... EXCEPT...

    I'm having a routing issue on my router. I can ping the outside world from the router. However, if I ping with a "source", the pings fails. For example, if I type...

    ping 4.2.2.2 source 172.16.1.1

    it fails when I add the source parameter on the ping command.

    Any suggestions on troubleshooting a routing issue? All routes are "connected" routes except for the one static gateway of last resort.

    Thanks in advance for your time and consideration.

    Your friend,
    Paul

    Sounds like a NAT issue on the router.
    Reply With Quote Quote  

  4. Diggin' 4 Cisco Gold ptlinva's Avatar
    Join Date
    Jan 2009
    Location
    Virginia, USA
    Posts
    124

    Certifications
    CCNA, CCENT, MCP, CNE, Red Hat Linux Admin - Diggin' for CCNA Voice!
    #3
    It was NAT... Thank you so very kindly, my friend!
    Reply With Quote Quote  

+ Reply to Thread

Social Networking & Bookmarks