+ Reply to Thread
Results 1 to 3 of 3
  1. Member
    Join Date
    Jul 2012
    Posts
    86
    #1

    Default AutoAttendant not transferring calls in CUE 8.6 to CME 9.1

    **Issue is calls are not transferring once extension or directory is pressed on the phone during the AA script.


    I upgraded our 2811 CME 7.1/CUE 7.0 router to 2911 15.2 CME 9.1/CUE8.6. It has CME and V/k9 license enabled. I uploaded the configuration used on the 2811 to the 2911. I added the ip addresses in the ip trusted list. Calls come in and out if I point the translation list to the phone extension and not to the auto attendant pilot number. Incase if it was toll fraud issue I disabled it but still a no go.


    Everything worked fine on the 2811. I can't understand why it would not work on the 2911 15.2. Has anyone had any issues when upgrading from 12.4 to 15.x with auto attendant not transferring calls?


    I ran a trace on the Cue when placed a call to extension 114:

    20.10.10.1- CME interface address
    20.10.10.5- CUE interface address
    659 09/12 11:43:39.418 ACCN SIPS 0 Call.transferFailed(114, RESOURCE_NOT_ACKNOWLEDGING) SIPCallContact[id=33,type=Cisco SIP Call,implId=5738D3Dse-20-10-10-5# 8947-4E978639@20.10.10.1,active=true,state=CALL_ANSWERE D,inbound=true,handle
    Reply With Quote Quote  

  2. SS -->
  3. Senior Member
    Join Date
    May 2009
    Location
    DMV
    Posts
    2,202

    Certifications
    CCNP, CCNP(V), S+ CCIE V(written)
    #2
    post a debug ccsip messages.
    Currently Reading

    CUCM SRND 9x/10, UCCX SRND 10x, QOS SRND, SIP Trunking Guide, anything contact center related
    Reply With Quote Quote  

  4. Member
    Join Date
    Jul 2012
    Posts
    86
    #3
    Just an update after revisiting the issue to rule out a configuration issue I chose to rebuild it from scratch and chose not copy and paste from the 2811. I used the Recommended initialization in the CUE Gui which helped me figured out the issue.

    This was the original 2811 config I copied and pasted in the 2911 which was working fine on the 2811:

    ccn subsystem sip
    gateway address "1.1.1.1"
    mwi envelope-info
    mwi sip sub-notify
    transfer-mode blind
    end subsystem

    After the initialization on the 2911 this was the output:

    ccn subsystem sip
    gateway address "1.1.1.1"
    mwi sip sub-notify
    end subsystem

    I checked and the calls transferred at this point.

    I wanted to mirror the new config to the old one and added everything from the previous config.

    mwi envelope-info
    transfer-mode blind

    I checked transfer through AA now no transfer..hmmm...I then removed each line to see if it had a different response. I found the issue was with :

    transfer-mode blind

    Once I removed that line calls transferred.
    Reply With Quote Quote  

+ Reply to Thread

Social Networking & Bookmarks