+ Reply to Thread
Results 1 to 4 of 4
  1. Senior Member AlanJames's Avatar
    Join Date
    Nov 2007
    Location
    Australia
    Posts
    231

    Certifications
    CCNP CVoice ITIL IPTEL1
    #1

    Default 2nd network card of CCM server

    Hey All,

    How does one configure the 2nd network card of Cisco call manager 5.1 server?
    I’m wanting to set up a redundant link to a redundant switch, But I couldn’t see anywhere in the CallManager Operating system to configure the 2nd Ethernet port on the ccm server.

    On the cisco doco “Cisco Unified CallManager Operating System Administration Guide, Release 5.1(1)”
    I read the below.

    Ethernet Settings

    The IP Settings window indicates whether Dynamic Host Configuration Protocol (DHCP) is active and also provides the related Ethernet IP addresses, as well as the IP address for the network gateway.
    All Ethernet settings apply only to Eth0. You cannot configure any settings for Eth1. The Maximum Transmission Unit (MTU) on Eth0 defaults to 1500.


    So, according to cisco this network card Eth1 can’t be configured, has anybody had any experience with this? Whats the best practice?

    Thanks All



    Reply With Quote Quote  

  2. SS -->
  3. Senior Member AlanJames's Avatar
    Join Date
    Nov 2007
    Location
    Australia
    Posts
    231

    Certifications
    CCNP CVoice ITIL IPTEL1
    #2
    I'm thinking the 2nd network card is not meant to be used, and the subscriber to be plugged into the redundant switch?
    Reply With Quote Quote  

  4. Senior Member AlanJames's Avatar
    Join Date
    Nov 2007
    Location
    Australia
    Posts
    231

    Certifications
    CCNP CVoice ITIL IPTEL1
    #3
    for reference you need to log into the console with command line access and enter "set network failover enable" This will make the 2nd port activate when the 1st network port fails.

    Just need to test now
    Reply With Quote Quote  

  5. Member
    Join Date
    Oct 2006
    Posts
    74
    #4
    Been there, done that. Look for this post "UCM 6.x network teaming?" in the same forum. Version 5 should be the same.
    Reply With Quote Quote  

+ Reply to Thread

Social Networking & Bookmarks