+ Reply to Thread
Results 1 to 4 of 4

Thread: 2651XM Router

  1. Junior Member
    Join Date
    Feb 2007
    Posts
    10
    #1

    Default 2651XM Router

    Have purchase this for Voice work ( hasnt any cards in it at present )
    has 64kb of Main mem and 32kb of flash
    what IOS do I need to get to use CME ?
    my IOS at present is C2600xm-is-mz-122.12a.bin

    Im assuming I will need another IOS and will then be able to use CME
    and then need PVDMs and VIC cards for analogue to digital stuff i.e FXS

    Thanks in advance for any help
    Reply With Quote Quote  

  2. SS -->
  3. Cisco Moderator mikej412's Avatar
    Join Date
    May 2005
    Location
    Chicago
    Posts
    10,190

    Certifications
    CCNP CCIP CCSP CCVP CCDP CCDA CCNA CS-CIPSS CS-CIPTDS CS-CIPTOS CS-CIPCSS CS-CFWS CS-CVPNS CS-CISecS ISSP 4013 4011
    #2
    The IOS you need is dependent on the version of CME you want to run.

    Check out the Cisco Unified Communications Manager Express Compatibility Information web page.

    The Cisco Unified CME and Cisco IOS Software Version Compatibility Matrix shows you the IOS Version and the supported CME Version.

    If you dig through the "Supported Firmware, Platforms, Memory, and Voice Products" documents, you'll find that the last version of CME the 265xXM supported was 4.1

    The 265xXM doesn't have any slots for PVDMs or VWICs, so it depends on the modules you install.

    You can find some hardware links in the CCVP FAQ

    If you go to Portable Product Sheets - Partner Central the NM/WIC/VWIC Compatibility PDF and the Voice Density PDF should give you an idea of what the 265xXM supports.
    Reply With Quote Quote  

  4. Junior Member
    Join Date
    Feb 2007
    Posts
    10
    #3

    Default Memory upgrade

    thanks for the info Mike, I think I will need a memory upgrade to run 12.4 Voice IOS
    Reply With Quote Quote  

  5. Senior Member pitviper's Avatar
    Join Date
    May 2008
    Location
    Right Coast, US
    Posts
    1,363

    Certifications
    CCNP:Collaboration, CCNP:R+S, CCNA:R+S, CCNA:V(IIUC), CCNA:S, CCENT, CNSS 4011
    #4
    Quote Originally Posted by blowfish View Post
    Im assuming I will need another IOS and will then be able to use CME
    and then need PVDMs and VIC cards for analogue to digital stuff i.e FXS

    Thanks in advance for any help
    NM-1V and NM-2V moudules have DSP resources built in to run the FXO and FXS VICs.

    For packetized voice, say T1/E1 PRI, you would need something like the NM-HD-2VE + a multiflex card like the VWIC-xMFT-T1. I'm sure you can use other "NM-HD" variations but you'll have to do some research.
    Reply With Quote Quote  

+ Reply to Thread

Social Networking & Bookmarks