+ Reply to Thread
Results 1 to 3 of 3
  1. Senior Member rchase's Avatar
    Join Date
    Nov 2011
    Location
    Valparaiso, IN
    Posts
    125

    Certifications
    CCNP Voice, CCNA, CCNA Sec, Linux+, Symantec, TCTS, TCTE, MCTS Win7, MCTS SBS 2011, Net+, Sec+
    #1

    Exclamation CIPT1 Students and Masters:

    How are you studying/How did you study for CIPT1? What did it take to get CUCM up? Any CIPT1 study advice welcome.


    Thanks,
    RCHASE
    Last edited by rchase; 10-21-2012 at 07:42 AM.
    Reply With Quote Quote  

  2. SS -->
  3. Senior Member
    Join Date
    Oct 2007
    Location
    Austin, TX
    Posts
    483

    Certifications
    A+, Network+, MCP, CCNA, CCNA:Voice, CCDA, CCDP, CCNP R/S, JNCIA, JNCIS
    #2
    I can't really comment on CIPT1 to much as we're both in the same boat as far as getting started. Installing CUCM is a pain getting it going in VM but that may just be my personal experience.

    Shawn Moore's Cisco Trek: Prepping Hardware and Software for CIPT1

    The install is VERY specific about the hardware requirements and the Subscriber is picky about having a NTP a low Stratum source. Like you can't just a windows server as it doesn't consider it's stratum low enough. I tricked my subscriber my setting up a random Cisco router I had laying around as a NTP server and pointed the Subscriber towards that until the install was complete.

    I actually have to setup my entire lab again so this should be fun and good review.
    My Cisco Blog Adventure: http://shawnmoorecisco.blogspot.com/

    Don't Forget to Add me on LinkedIn!
    https://www.linkedin.com/in/shawnrmoore
    Reply With Quote Quote  

  4. The Undeniable!!! jahsoul's Avatar
    Join Date
    Mar 2010
    Location
    War Eagle Country
    Posts
    448

    Certifications
    A few
    #3
    I modified my callmanager_product.conf file and I run my VM on a 50GB/1.5GB RAM setup. Also, I've never ran into an issue setting up the Sub NTP but the Pub must be associated with an NTP server no less than Stratum 6. I use pfSense, so I set up ntpd for each network, so I just pointed my Pub to that for initial install and I have my PSTN router synced to that as well, with each site router synced to my PSTN.
    Reply With Quote Quote  

+ Reply to Thread

Social Networking & Bookmarks